Home Mechanical/Hydraulic Repair Hydraulic Cylinder Repair
Save Money With K+S Services

Hydraulic Cylinder Repair

K+S Services has over 40 years of experience repairing hydraulic cylinders. Our repair process is rooted in this experience, along with our commitment to precision and durability. Whether we’re repairing single-acting cylinders or tie-rod configurations, you can trust our team for reliability, quality workmanship, and cost-efficient solutions.

Factory-Certified Repairs

Brands We Repair

View All Brands

Every technician at K+S Services is factory-certified to service a wide range of hydraulic cylinder brands, including Miller and Rexroth. We have experience repairing cylinders up to 32 feet in length, 36 inches in diameter, and 40,000 pounds.

miller welder repair
When to Call for Repair

Are You Experiencing Any of These?

Your hydraulic cylinder needs repaired if you’ve noticed:

  • Visible leaks or seepage.
  • Decreased force or slow movement.
  • Unusual noises during operation.
  • Visible wear on rods or seals.

ISO Certified Quality
The K+S Difference

Specializing in Reconditioning & Remanufacturing

K+S Services doesn’t just perform functional repairs. We ensure every hydraulic cylinder leaving our facility has been fully reconditioned to meet OEM performance specifications. Repair processes are tailored based on the type of cylinder being repaired, whether single, double-end, or telescopic, and we document every repair project in our ISO 9001:2015-compliant quality management system.

Step 1

Evaluation

Our hydraulic cylinder reconditioning process starts with a precision diagnosis. First, we carefully disassemble the cylinder. Then, we clean and inspect every component for wear, degradation, and in some cases, misalignment.

Step 2

Analysis Report

After our thorough evaluation, we’ll update you on what we found, including any probable causes of damage or failure, and provide repair cost and timeline estimates.

Step 3

Repair

We find a factory-certified technician best suited for the type of cylinder repair required. Any damaged components are replaced with OEM spares. K+S also has an in-house machining department that can remanufacture discontinued/obsolete rods, pistons, bushings, and tubes.

Step 4

Diagnostics

We perform comprehensive pressure and leak testing to ensure our repairs were successful and to verify that the cylinder meets OEM specifications.

Step 5

Post-Repair

You’ll receive your reconditioned cylinder, along with installation and maintenance instructions, a list of which components were replaced or remanufactured, and details from our pressure and leak testing.

Hydraulic Cylinder Repair

Resources

View All Resources

Find a Rep

Use our convenient representative locator to find a K+S rep near you that can assist you in repairing your components today.

Resources

The K+S Resource library is a searchable, comprehensive repository of all documents related to K+S. Whether you are looking for our line cards, or application-specific documentation, you will be able to find it in the Resource library below.

View Resources
Top